We independently review everything we recommend. When you buy through our links, we may earn a commission. Learn more›

CEER vs EER Ratings: Reading AC Efficiency Labels

CEER vs EER air conditioner ratings explained, plus a simple way to turn the number into cost per season for a window or portable unit.

CEER vs EER for air conditioners: both measure cooling efficiency as BTUs of cooling per watt of electricity, and higher is better. EER measures efficiency while the unit is running, and CEER, the combined energy efficiency ratio used for room air conditioners, also counts the small power the unit draws on standby. Use CEER to compare room air conditioners, and use EER only when CEER is not listed.

What the Ratings Measure

EER stands for energy efficiency ratio. It is the cooling output in BTUs per hour divided by the electrical power input in watts, measured under a set of standard conditions: about 95 degrees F outdoors, 80 degrees F indoors, and 50 percent humidity. A higher EER means the unit delivers more cooling for each watt it draws.

CEER stands for combined energy efficiency ratio. It was introduced by the Department of Energy for room air conditioners to give a fuller picture. It uses the same cooling output, but the power in the denominator includes standby and off-mode power in addition to the active cooling power. Because the unit sits plugged in for months and draws a little power all the time, CEER gives a more realistic annual picture.

Both ratings measure efficiency, not size. A unit with a high EER can still be too small or too large for your room, so match capacity first, then compare efficiency.

How CEER and EER Relate

For most units, the CEER value is slightly lower than the EER, because adding standby power lowers the result. The gap is usually small, since standby power is a small fraction of the active draw. That means two units with similar EER may have slightly different CEER, and CEER is the fairer number to use when you compare room air conditioners from different makers.

RatingWhat it countsWhere you see it
EERCooling output divided by running powerOlder labels, some product pages
CEERCooling output divided by running plus standby powerRoom air conditioner EnergyGuide labels, ENERGY STAR
SEER or SEER2Seasonal efficiency across varying outdoor temperaturesCentral air conditioners and heat pumps

Do not compare CEER or EER numbers with SEER numbers. They use different conditions, and SEER typically reads higher.

Worked Example

Suppose a room air conditioner has a cooling capacity of 10,000 BTU per hour and draws about 900 watts while running. Its EER is 10,000 divided by 900, which is about 11.1. If it also draws a small standby power, the CEER comes out a little lower than 11.1. A second unit with the same capacity draws 1,000 watts, which gives an EER of 10. The first unit uses about 100 fewer watts for the same cooling.

To turn this into running cost, multiply watts by hours of use and divide by 1,000 to get kilowatt-hours, then multiply by your electric rate. A unit that runs 8 hours a day at 900 watts uses about 7.2 kilowatt-hours per day. At 1,000 watts, it uses 8. Over a summer, the difference adds up, though it is modest compared with the effect of choosing the right size.

How to Use the Ratings When Shopping

1. Choose capacity first. Match BTU to the room size, ceiling height, sun exposure, and number of people. A unit that is too large short-cycles and dehumidifies poorly, and one that is too small runs constantly. 2. Compare CEER among units of similar capacity. Higher CEER means lower running cost. 3. Check for ENERGY STAR certification. ENERGY STAR labeled room air conditioners must meet efficiency requirements set by the program, and the requirements can change, so check the current listing. 4. Read the EnergyGuide label, which shows estimated annual energy cost based on assumptions about hours and rate. 5. Consider features that save energy, such as a timer, a thermostat, a sleep mode, and an eco mode. 6. Compare your local electric rate and hours of use, since savings depend on how much you run the unit.

Our air conditioner guides explain how to size a unit and choose a type. For related products, see the home appliances hub. Our How We Review page explains how we evaluate products using research and specifications rather than claims of our own trials.

What About Portable and Window Units?

Window units and many through-the-wall units list CEER. Portable air conditioners are rated differently under newer federal rules, using a seasonally adjusted cooling capacity and a combined efficiency measure, since the way they pull indoor air and exhaust it changes performance. If a portable unit lists a different metric, compare it only with other portable units. Dual-hose portables are often more efficient than single-hose designs, but check the specifications.

Inverter-driven units, which vary compressor speed, can use less energy in real use than the rating suggests, since ratings come from fixed conditions. Check whether the unit is an inverter model and read its stated efficiency.

Why Efficiency Is Not the Only Factor

  • Capacity fit: an efficient but oversized unit still wastes energy and comfort.
  • Installation: gaps around a window unit leak cool air.
  • Placement: shade on the outdoor side and a clean filter help the unit work well.
  • Noise: check the decibel rating if the unit is in a bedroom.
  • Voltage and circuit: large units may need a dedicated circuit. Follow the manual and use a licensed electrician if a new outlet is needed.
  • Maintenance: a dirty filter and clogged coils cut efficiency.

Mistakes to Avoid

  • Comparing a CEER number with a SEER number.
  • Choosing by efficiency alone and ignoring capacity.
  • Assuming a higher number always pays off in a room used a few days a year.
  • Ignoring installation gaps and filter upkeep.
  • Mixing up BTU, which is capacity, with efficiency.

Sizing the Capacity Before You Compare Efficiency

Efficiency only matters once the unit fits the room. As a rough starting point from public guidance, a room air conditioner needs a certain number of BTU per square foot of floor area, with adjustments for sun, ceiling height, the number of people, and a kitchen. A very small room may need a smaller unit than you expect, and a sunny room may need more. Check the sizing table in the maker’s manual or on the ENERGY STAR page for room air conditioners, and avoid guessing. If a room is between sizes, consider ceiling height and sun, and avoid going far above the recommended range, because an oversized unit cools quickly, shuts off, and leaves the air humid.

Reading an EnergyGuide Label

The yellow EnergyGuide label on room air conditioners shows the estimated yearly operating cost, the CEER, and a comparison range for similar models. The cost figure is based on a stated number of hours and an average electric rate, so your own cost may differ. Use the label as a way to compare models, not to predict your bill. If your summers are long and hot, your cost will be higher than the label suggests, and the efficiency difference between units matters more. If you use the unit only on a few hot weekends, the label’s cost will overstate it, and a higher efficiency model pays back more slowly.

When a Higher Rating Pays Off

Higher efficiency pays off when you run the unit many hours per year, when electricity rates are high, and when you keep the unit for many seasons. It pays off less in a guest room used rarely. Estimate the difference in annual energy between two models by subtracting their watts at the same capacity, multiplying by hours of use, and dividing by 1,000. Multiply the result by your rate, and compare it to any price difference. Remember that other costs matter too: noise, features, warranty, and installation.

Installation and Electrical Safety

Follow the manual for mounting, support brackets, and sealing. Use the supplied power cord and plug it into a grounded outlet on a circuit that matches the unit’s requirement, with nothing else on the circuit if the manual says so. Do not use extension cords or adapters. If the plug or cord feels hot, unplug the unit and stop using it. For a new outlet or a dedicated circuit, hire a licensed electrician. Secure window units properly so they cannot fall, and ask for help lifting them, since they are heavy.

Frequently Asked Questions

What is the difference between EER and CEER?

Both measure cooling per watt, but CEER also includes standby power, so it is a fuller picture for room air conditioners. EER counts only running power. Use CEER to compare room units, and EER only when CEER is not listed.

Is a higher CEER better?

Yes. A higher CEER means more cooling for each watt, which lowers running cost for the same capacity. Compare units of similar BTU, since efficiency ratings do not tell you whether the unit fits your room.

Can I compare CEER with SEER?

No. SEER and SEER2 measure seasonal efficiency across a range of outdoor temperatures for central systems, while EER and CEER use a single set of conditions. The numbers are not directly comparable, so compare within the same rating type, such as CEER to CEER or SEER2 to SEER2.

How much does CEER matter for a small room?

It matters less than correct sizing, but it still affects running cost, especially if you run the unit every day. Pick the right BTU, then choose the highest CEER you can reasonably get, and check ENERGY STAR labels and the EnergyGuide estimate for your use.

Final Thoughts: Size First, Then Compare CEER

CEER is the better number for room air conditioners, since it counts standby power. Choose the right capacity, compare CEER among similar units, check ENERGY STAR, and use the EnergyGuide label to estimate running cost.

Related buying guides

About the author

BuyOnceChoice Editorial Team
BuyOnceChoice Editorial Team

The BuyOnceChoice Editorial Team researches durable products worth buying once. Our guides compare published specifications, warranty terms, expert review consensus, and verified owner feedback. We do not conduct our own product trials. See How We Review and our Editorial Policy for our standards.