We independently review everything we recommend. When you buy through our links, we may earn a commission. Learn more›

Snow Blower Safety: Clogs, Chutes, Carbon Monoxide

Practical safety habits for clogs, chute handling, refueling, garage warmups and kids and pets, based on common manufacturer guidance and your manual.

Snow blower safety comes down to a few habits: shut the engine off and wait for all parts to stop before touching a clog, run a gas engine only outdoors, keep people and pets clear of the chute and follow the manual for fuel and electrical use. Never clear a clog with your hands, even when the engine is off, and never run a gas engine in a closed garage.

Clearing Clogs the Safe Way

Clogs are the biggest source of snow blower injuries. A blocked chute or auger can look harmless, but the auger and impeller can hold tension, and a machine that is running or recently stopped can move without warning. Never reach into the chute or auger with your hand or foot.

Follow this sequence:

  • Release the handle control and shut off the engine, or turn off and remove the key on electric models.
  • Wait for the auger and impeller to stop completely. They can keep spinning for a few seconds after shutdown.
  • Disconnect the spark plug wire on gas models, or remove the battery or unplug the cord on electric ones, if the manual advises.
  • Use the clearing tool that came with the machine, or a stick or a broom handle to remove packed snow. Use a tool, never a hand.
  • Check that the area is clear before restarting.

If the clog returns often, the snow may be too wet, the chute may be set poorly or you may be moving too fast. Slow down and take smaller passes. Some owners use a nonstick spray on the chute, if the manual allows, to reduce sticking.

Prevent clogs instead of fixing them. Clear snow soon after a storm rather than letting it settle and refreeze. Take overlapping passes and avoid taking full width bites of heavy, wet snow. Keep ground speed steady, since going too fast overloads the auger. If you are working with slush, lower the engine speed or take narrower cuts as the manual advises. Park the machine in a cold place before use, so that it is not warmer than the snow, which can make wet snow stick to the housing. Clear the chute and auger after you finish, then let the machine run for a minute to throw off snow before shutdown.

A clog that you cannot clear with a tool is a sign to stop and check the machine. A stuck auger can mean a frozen cable, a broken shear pin or a jammed object. Follow the manual, and call a technician if you are unsure.

Carbon Monoxide and Where to Run the Engine

Gas engines produce carbon monoxide, a colorless and odorless gas that can build up quickly in enclosed spaces. Never start or warm up a snow blower in a garage, shed or basement, even with the door partly open. Move the machine outdoors before starting it, and keep the exhaust away from doors, windows and vents so fumes do not drift into the house. Install carbon monoxide alarms on each level of your home and outside sleeping areas, and check them as the alarm maker advises. If an alarm sounds or you feel dizzy, nauseous or have a headache, get to fresh air and call emergency services.

Cold weather can tempt you to warm up the engine in the garage, but that is when exposure becomes dangerous. Start it outside and let the engine run there.

Chute Handling and Discharge Direction

Point the chute away from people, pets, cars, windows and the street. Snow and hidden debris like stones, ice chunks or newspaper can be thrown with force. Check the area before you start, and clear toys, doormats and loose objects from the path. Set the chute direction and deflector before you start the engine, not while the machine is moving, unless the manual says the control is safe to use during operation. Do not throw snow onto roads or toward neighbors.

Think about where the snow goes. Plan your path so that you throw snow downwind where possible, and avoid pushing it across areas you will need later. Do not point the chute at windows, vehicles or neighbors, since packed snow and ice can break glass and dent panels. Check your driveway edge for stones and newspaper before starting. If you hear a bang or feel a jolt, stop and shut the engine off before you look for the cause.

Fuel, Refueling and Electrical Safety

Add fuel only when the engine is off and cool, outdoors and away from sparks or flames. Use fresh fuel and the grade the manual specifies, and store fuel in an approved container, away from living spaces. Do not refuel a hot engine. Wipe up spills before starting.

For electric models with a cord, use an outdoor rated extension cord of the gauge and length the manual allows, and keep the cord clear of the auger path. Do not use damaged cords or plug into an outlet that is not rated for outdoor use. For battery models, follow the charger instructions and keep batteries dry. A licensed electrician should handle any outdoor outlet installation.

Store gasoline only in approved, labeled containers, in a detached shed or garage away from the house, and never near a water heater or other flame. Do not siphon fuel by mouth. If fuel spills on your clothes, change them. For electric machines, keep the plug and cord connection out of snow and slush, and route the cord behind you so you never run over it. Unplug the machine before inspecting it, and keep the cord off wet ground when you stop for a break. Never modify a cord or plug, and replace damaged parts.

Clothing, Footing and Workspace

Wear boots with good grip, snug gloves, eye protection and hearing protection if the manual recommends it. Avoid loose scarves, drawstrings or dangling clothing that could catch on moving parts. Clear ice from the path and use salt or sand where you walk. Work during daylight if you can, and use good lighting at night. On slopes, go across carefully only as the manual allows, and avoid steep ground where the machine can slide or tip.

Take breaks. Snow removal is hard exercise, and people with heart conditions or other health concerns should check with their doctor before shoveling or operating a heavy machine.

Kids, Pets and Bystanders

Keep children and pets indoors while you clear snow, and never let a child operate or ride on a snow blower. Do not leave a running machine unattended. Look behind you before backing up. Tell neighbors or family members that you are working so they can stay clear.

Build a routine that protects everyone. Tell family members before you start and where you will be working. Keep children and pets inside until you finish. Do not let anyone ride on or stand near the machine. If you hire a neighbor or a service, make sure they have the manual and understand the safety rules. Store the machine out of reach of children, with the key removed and fuel stored safely.

Maintenance That Prevents Accidents

Check the machine before the season. Inspect the control bars, the safety stop and the shear pins and replace worn parts as the manual directs. Make sure guards and shields are in place. Check belts, tires and chute controls. Keep the machine clean and dry in storage. Do not remove or disable safety devices. See the snow blower category, the small gas powered snow blower roundup and How We Review.

Check the safety controls before the first storm. The dead man control, which stops the auger when you release the handle, should return fully and cut the auger within seconds. If it does not, stop using the machine and repair or replace the part. Replace worn or missing shields, and do not use a machine with a damaged chute or a loose auger. Keep a log of service dates and parts. If you buy a used machine, ask for its manual and check the safety features carefully.

Frequently Asked Questions

How do I clear a snow blower clog safely?

Release the controls, shut off the engine and wait for the auger and impeller to stop completely. Then use the clearing tool or a stick, never your hand. Disconnect the spark plug or power source if the manual advises, and check the area before restarting.

Can I run a snow blower in the garage?

No. Gas engines produce carbon monoxide that can build up in minutes, even with the garage door open. Start and warm the engine outdoors, keep the exhaust away from doors and windows, and use carbon monoxide alarms in your home.

Is it safe to refuel a snow blower when the engine is hot?

No. Turn off the engine and let it cool before refueling, and do it outdoors away from sparks and flames. Wipe up spills, use an approved container and store fuel away from living areas, following the manual.

Why does my snow blower keep clogging?

Wet, heavy snow, a chute that is set poorly, moving too fast or a worn scraper are common causes. Slow down, take smaller passes, clear more often during a storm and check the manual for adjustments. Always stop the engine before clearing.

Final Thoughts

Stop the engine and wait for every part to stop before touching a clog, use a tool instead of your hand and run gas engines only outdoors. Keep people clear of the chute, refuel cold engines safely and use a licensed electrician for any outdoor wiring.

Related buying guides

About the author

BuyOnceChoice Editorial Team
BuyOnceChoice Editorial Team

The BuyOnceChoice Editorial Team researches durable products worth buying once. Our guides compare published specifications, warranty terms, expert review consensus, and verified owner feedback. We do not conduct our own product trials. See How We Review and our Editorial Policy for our standards.