How Long Do Washers and Dryers Last: Repair Rules
Washers and dryers fail in predictable ways. Learn which parts are cheap to fix, which repairs signal the end, and a simple cost rule for repair or replace.
How long does a washing machine last depends on load size, water quality, design and care, and manufacturers do not publish a guaranteed figure, so judge each failure by the part and the quote rather than by age alone. A practical rule is to repair when the fix costs well under half of a comparable new machine and the drum, bearing and cabinet are sound.
What Shapes Washer and Dryer Lifespan
Washers and dryers age through use, not just time. Several factors matter.
- Number of loads. A family running many loads a week puts more cycles on the machine than a couple.
- Load size. Overloading strains the drum, bearings, motor and suspension.
- Water quality. Hard water leaves scale on valves and heating elements, and sediment can clog filters.
- Level and floor. An unlevel machine vibrates and wears parts faster.
- Maintenance. Clean filters, clear vents and fresh hoses prevent many failures.
- Design. Simpler machines with fewer sensors and boards have fewer ways to fail.
We do not give a number of years, since none can be guaranteed. Instead, look at warranty length, parts availability and service access when you buy.
Commonly cited home industry planning figures put washers at roughly 10 years and dryers at roughly 13 years, but those are averages across many homes, not a promise for your machine, and heavy use or poor care can shorten them. Use them only to judge whether a repair quote is for a young or an old machine, and rely on the warranty and parts support for the machine in front of you.
Common Failing Parts in Washers
Most washer problems fall into a handful of categories.
- Drain pump or filter clog: water stays in the drum, or the machine stops mid cycle. Often a coin, sock or lint clog, fixed by cleaning the pump filter.
- Door lock or lid switch: the machine will not start or will not spin. Parts are usually inexpensive.
- Water inlet valve: slow fill or no water. Scale and sediment are common causes.
- Door gasket on front loaders: leaks or odor. Replaceable on most models.
- Belt and motor coupling on some designs: slipping or poor spin.
- Shock absorbers or suspension: violent shaking during spin.
- Drum bearing: a loud rumble or grinding during spin. This is often the costliest repair, since it can involve taking the machine apart.
- Control board: display faults, error codes or no response.
Common Failing Parts in Dryers
Dryers have fewer parts, and many failures are simple.
- Heating element or igniter: the drum turns but the air stays cool. The element on electric dryers and the igniter on gas dryers are common wear parts.
- Thermal fuse or thermostat: the dryer stops heating, often because of a blocked vent.
- Drum belt: the drum stops turning and you hear the motor run.
- Drum rollers or glides: squealing or thumping.
- Motor: the least common but costly.
- Moisture sensor or control board: poor drying or cycle faults.
Many dryer faults trace back to a restricted vent. Our guide to dryer vent safety explains how to keep it clear.
Cheap Fixes to Try First
Before paying for service, check the simple items.
- Clean the washer’s drain pump filter and the inlet hose screens.
- Check that the washer is level and the lid or door closes completely.
- Remove coins and small items from the drum and gasket.
- Clean the dryer’s lint trap and vent.
- Reset the machine by unplugging it for a few minutes, as the manual allows.
- Check the breaker, since a tripped breaker can mimic a dryer failure.
Shut off the water supply and unplug the machine before opening panels, and use a licensed professional for gas, electrical and plumbing work.
The Repair or Replace Rule
1. Get a written diagnosis and a quote that lists parts and labor.
2. Compare with the cost of a comparable new machine.
3. If the repair costs well under half of a new machine, and the machine is otherwise sound, repair it.
4. If a washer needs a bearing or a transmission, or a dryer needs a motor, and the machine is not young, lean toward replacement.
5. If the machine has needed repeated repairs, replace it.
Age shifts the odds. A modest repair on a younger machine is a good bet. A major repair on an old machine invites the next failure. For a washer and dryer pair, consider whether the other machine is also near the end, since pairs often age together and matching a new set can simplify the installation.
Habits That Extend Life
- Do not overload the drum, and balance heavy items.
- Use the right amount of high efficiency detergent.
- Wipe the front load gasket and leave the door ajar.
- Replace worn supply hoses as the manual advises, since a burst hose can cause serious flood damage.
- Clean the dryer’s lint trap each load and the duct each year.
- Keep the machines level and on a firm floor.
- Run a cleaning cycle on the schedule in the manual.
Reading a Repair Quote
A quote should name the failed part, the part price, labor and any service call fee. Ask whether the part is new or refurbished, and for how long the repair is warranted. A diagnostic fee that is credited toward the repair is common. A bearing quote for a front loader can approach the price of a new machine, so compare before you agree. If the technician finds more than one worn part, ask which ones are urgent and which can wait. A second opinion is inexpensive compared with replacing a machine you could have kept.
Signs the End Is Near
A single fault is not the end, but a pattern is. Be ready to replace if you see several of these: loud grinding that continues after cleaning, rust spots on the drum or cabinet, repeated leaks, control errors that return after a reset, laundry that never comes out clean or dry and a rising number of service calls. Combine these with age and the quote, and the answer usually becomes clear.
What to Look for in a Replacement
Use the failed machine as a lesson. If a bearing failed, look at the warranty on the drum and bearing. If gaskets and odors annoyed you, choose a design that suits your habits, such as a top load or a model with a self clean routine. If vents caused trouble, fix the duct before installing a new dryer. Check capacity, width and the path into the room, as our guide to washer capacity suggests, and confirm that parts are sold for the brand.
A Note on Pairs
Washers and dryers often arrive together and age together. If one fails and the other is of similar age, ask whether replacing both makes sense, since a mismatched set can leave you with different capacities, and the cost of a single new unit may not save much if the other follows soon. Check the hookups and the vent before you commit.
Whichever machine fails first, write down the model and serial numbers of both from the nameplates. A technician can look up parts and manuals faster with them, and you will have the data ready when you compare replacement models.
Decision Rules
- Young machine, drain, valve or lock fault: repair.
- Bearing failure on an older washer: replace.
- Dryer heating element or belt: usually repair.
- Repeated failures within a short time: replace.
- Leaks that damage the floor: shut off water and fix or replace promptly.
- Planning the next purchase: see our guides in the washers and dryers category and the home appliances section.
Frequently Asked Questions
How long does a washing machine last?
Commonly cited planning figures put washers at roughly 10 years, but use, water quality, load size and care change that a lot. No maker guarantees a lifespan. Judge each failure by the failed part, the quote and the age of the machine, and check the warranty and parts support rather than a single number.
How long does a dryer last?
Commonly cited planning figures put dryers at roughly 13 years. Dryers have fewer parts than washers, and many failures trace to a restricted vent, so keeping the duct and lint trap clean matters. Heating elements, igniters, belts and thermal fuses are common repairs that are often worth doing.
Is it worth repairing a washing machine?
Usually yes when the repair costs well under half of a comparable new machine and the drum, bearing and cabinet are sound. A bearing or transmission repair on an older washer is more likely to be a replacement case. Get a written quote listing parts and labor before deciding.
Should I replace a washer and dryer at the same time?
Not automatically. If one machine fails and the other is of similar age, ask whether the second is near the end too, since pairs often age together. Replacing both can match capacity and simplify installation, but a young machine with a good record is worth keeping.
Final Thoughts
There is no fixed lifespan for a washer or dryer, so judge each failure on its own. Try the free fixes, get a written quote, apply the half of replacement cost rule and be wary of bearing and motor failures on older machines. Keep vents clear and hoses fresh, and favor machines with good warranties and parts support when you replace them. See how we review for how we weigh these factors.
Related buying guides
- How to Clean a Washing Machine and Prevent Mold
- Stackable vs Side by Side Washer Dryers
- Washer Capacity Guide: Cubic Feet by Household Size